Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (w/ Entry and Start System) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255571 THEFT DETERRENT SYSTEM(w/ Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM(w/ Entry and Start System)  B2768  Tilt Sensor Internal Circuit Malfunction  


DESCRIPTION

This DTC is stored when one of the following occurs: 1) yaw rate sensor power supply malfunction; 2) yaw rate sensor open malfunction; or 3) EEPROM malfunction.

DTC Code DTC Detection Condition Trouble Area
B2768 If one of the following is detected:
·

A yaw rate sensor power supply malfunction.

·

A yaw rate sensor open malfunction.

·

An EEPROM malfunction.


·

Yaw rate sensor

·

Certification ECU (Smart key ECU assembly)



PROCEDURE

1.CHECK FOR DTC (OPERATION)

b.

Turn the engine switch on (IG), then off.


c.

Set the theft deterrent system to the armed state.


d.

Check that the security indicator changes from illuminated to flashing.


e.

Set the theft deterrent system to the disarmed state.




OK

NG

2.CHECK YAW RATE SENSOR (OPERATION)
2.CHECK YAW RATE SENSOR (OPERATION)
a.

Temporarily replace the yaw rate sensor that has a tilt determining function with a new or normally functioning one (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR (w/ VSC)>REMOVAL).


b.

Check that the system operates normally.

OK:

DTC B2768 is not output.




OK

END (YAW RATE SENSOR IS FAULTY)

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)