Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2015.08
RM2660E _58 Vehicle Interior _052841 METER / GAUGE / DISPLAY _0255598 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Operating Light Control Rheostat does not Change Light Brightness  


DESCRIPTION

w/ Multi-information Display:

When the light control rheostat knob is turned to the left, the combination meter and vehicle interior illumination will become brighter. When the light control rheostat knob is turned to the right, the combination meter and vehicle illumination will dim.

WIRING DIAGRAM

E158833E03
1.809,0.793 2.597,0.942 0.788,0.149 10 TAIL Cancel 1.844,2.726 2.535,2.875 0.691,0.149 10 ODO/TRIP 2.992,0.758 3.211,0.907 0.218,0.149 10 TC 3.1,1.249 3.212,1.398 0.112,0.149 10 T 2.992,1.722 3.211,1.871 0.218,0.149 10 TR 3.097,2.219 3.212,2.368 0.114,0.149 10 E 2.964,2.673 3.211,2.815 0.246,0.142 10 A/B 1.546,3.203 1.743,3.352 0.198,0.149 10 E9 1.546,3.352 2.952,3.501 1.406,0.149 10 Light Control Rheostat 4.08,3.168 4.444,3.324 0.364,0.156 10 E119 4.405,0.66 4.624,0.809 0.218,0.149 10 TC 4.412,1.159 4.714,1.308 0.302,0.149 10 ILL+ 4.41,1.648 4.628,1.797 0.218,0.149 10 TR 4.398,2.217 4.596,2.359 0.198,0.142 10 E2 4.401,2.589 4.793,2.738 0.392,0.149 10 RSET 4.08,3.328 5.930,3.484 1.850,0.156 10 Combination Meter Assembly 3.246,0.565 3.347,0.728 0.100,0.163 10 6 3.251,2.492 3.352,2.655 0.100,0.163 10 4 3.242,2.038 3.343,2.201 0.100,0.163 10 1 3.245,1.548 3.345,1.710 0.100,0.163 10 7 3.248,1.067 3.348,1.230 0.100,0.163 10 5 4.184,0.569 4.361,0.711 0.177,0.142 10 32 4.247,2.509 4.361,2.651 0.114,0.142 10 8 4.188,2.043 4.365,2.185 0.177,0.142 10 19 4.191,1.56 4.368,1.702 0.177,0.142 10 31 4.191,1.076 4.368,1.218 0.177,0.142 10 30

PROCEDURE

1.READ VALUE USING GTS (LIGHT CONTROL RHEOSTAT)
a.

Operate the GTS according to the display and select Data List (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Tail Cancel SW* TAIL cancel switch condition/ON or OFF ON: TAIL cancel switch ON
OFF: TAIL cancel switch OFF
-
Rheostat value Light control rheostat switch input/Min.: 0, Max.: 100 Light control rheostat switch is fully turned right (0) → fully turned left (100) Unit: %

HINT:

*: w/ TAIL Cancel Switch


OK:

Light brightness can be changed within specified range by manual operation.




OK

REPLACE COMBINATION METER ASSEMBLY

NG

2.INSPECT LIGHT CONTROL RHEOSTAT
2.INSPECT LIGHT CONTROL RHEOSTAT
a.

Remove the light control rheostat (See page Vehicle Interior>METER / GAUGE / DISPLAY>LIGHT CONTROL RHEOSTAT>REMOVAL).


b.


OK

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - LIGHT CONTROL RHEOSTAT)

NG

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - LIGHT CONTROL RHEOSTAT)
a.

Disconnect the E119 meter connector.


b.

Disconnect the E9 rheostat connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E119-30 (ILL+) - E9-5 (T) Always Below 1 Ω
E119-31 (TR) - E9-7 (TR)
E119-19 (E2) - E9-1 (E)
E119-32 (TC) - E9-6 (TC)




OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR