Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255602 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY (w/ Rear No. 2 Seat)

a.
B181625

Install the curtain shield airbag with the 13 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)

NOTICE:

Do not twist the curtain shield airbag when installing it.



b.
B189318

After installing the bolts, put the curtain shield airbag onto the bracket and close the dual lock fastener.


c.

Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 2.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY (w/o Rear No. 2 Seat)

a.

Install the curtain shield airbag with the 10 bolts.

B183757

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)

NOTICE:

Do not twist the curtain shield airbag when installing it.



b.

Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 3.INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof)

Hide 4.INSTALL ROOF HEADLINING ASSEMBLY (w/o Sliding Roof)

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 6.CHECK SRS WARNING LIGHT