1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
45187
3.REMOVE LOWER NO. 3 STEERING WHEEL COVER
45186
4.REMOVE LOWER NO. 2 STEERING WHEEL COVER
5.REMOVE STEERING PAD
45100
6.REMOVE STEERING WHEEL ASSEMBLY
7.REMOVE LOWER STEERING COLUMN COVER
45286B
8.REMOVE UPPER STEERING COLUMN COVER
9.REMOVE SPIRAL CABLE
Disconnect the connectors from the spiral cable with steering sensor.
When handling the airbag connector, take care not to damage the airbag wire harness.
Detach the 3 claws and remove the spiral cable with steering sensor.
Detach the 6 claws and remove the spiral cable from the steering sensor.