Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Driver Side) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255606 KNEE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Driver Side)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RHD and LHD.

·

The procedures listed below are the LHD side.



PROCEDURE

Hide 73900 1.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

a.

Connect the connector.

B449543E01
0.292,0.073 0.906,0.292 0.615,0.219 12 false for LHD: 4.052,0.063 4.844,0.323 0.792,0.26 12 false for RHD:

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Install the driver side knee airbag with the 5 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 55432D 2.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55475A 4.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55474C 5.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55403C 6.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55449C 7.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 9. CHECK SRS WARNING LIGHT