Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Front Passenger Side) › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255607 KNEE AIRBAG ASSEMBLY(for Front Passenger Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Front Passenger Side)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 73990 1.INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B427378E01
2.59,2.807 1.988,2.966 false 1.795,2.884 1.982,3.040 0.187,0.156 10 *a

Connect the airbag connector and lock the connector lock.

Text in Illustration
*a Connector Lock

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



d.

Attach the 4 claws to install the front passenger side knee airbag assembly.


e.

Install the 4 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 55607 2.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55403C 3.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH (for Double Swing Out Type Back Door)

Hide 55402C 4.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH (except Double Swing Out Type Back Door)

Hide 55449C 5.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION (for Double Swing Out Type Back Door)

Hide 55448A 6.INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION (for Double Swing Out Type Back Door)

Hide 67914B 7.INSTALL FRONT DOOR SCUFF PLATE LH (for Double Swing Out Type Back Door)

Hide 67913B 8.INSTALL FRONT DOOR SCUFF PLATE RH (except Double Swing Out Type Back Door)

Hide 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 10. CHECK SRS WARNING LIGHT