Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255614 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.INSTALL REAR AIRBAG SENSOR

a.
B181652

Check that the ignition switch is turned off.


b.

Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Install the rear airbag sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that there is no looseness in the installation parts of the rear airbag sensor.


e.

Connect the connector.


Hide 62520P 2.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH (w/ Sliding Roof)

Hide 62520P 3.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH (w/o Sliding Roof)

Hide 71845B 5.INSTALL REAR SEAT COVER CAP (w/o Sliding Roof)

Hide 67918E 6.INSTALL REAR DOOR SCUFF PLATE LH (w/ Sliding Roof)

Hide 67918E 7.INSTALL REAR DOOR SCUFF PLATE LH (w/o Sliding Roof)

Hide 58574A 10.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE (w/ Sliding Roof)

Hide 58574A 11.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE (w/o Sliding Roof)

Hide 12.INSTALL REAR NO. 2 SEAT ASSEMBLY LH (for Split Bench Seat Type)

Hide 13.INSTALL REAR NO. 2 SEAT ASSEMBLY LH

Hide 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 15. CHECK SRS WARNING LIGHT