Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR FLOOR AIRBAG SENSOR › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255615 REAR FLOOR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR FLOOR AIRBAG SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR FLOOR AIRBAG SENSOR

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B181655

Install the rear floor airbag sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that there is no looseness in the installation parts of the rear floor airbag sensor.


e.

Connect the connector.


f.
B181654

Attach the clip, claw and cover.


g.

Return the floor carpet to its original position.


Hide 67917C 2.INSTALL REAR DOOR SCUFF PLATE RH (w/ Sliding Roof)

Hide 67917C 3.INSTALL REAR DOOR SCUFF PLATE RH (w/o Sliding Roof)

Hide 67918E 4.INSTALL REAR DOOR SCUFF PLATE LH (w/ Sliding Roof)

Hide 67918E 5.INSTALL REAR DOOR SCUFF PLATE LH (w/o Sliding Roof)

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)


Hide 9.CHECK SRS WARNING LIGHT