Use the same procedures for the RH and LH.
The procedures listed below are the LH side.
1.INSTALL CURTAIN SHIELD AIRBAG CUTOFF SWITCH
Attach the 2 claws to install the switch.
55446A
2.INSTALL NO. 1 SWITCH HOLE BASE
55432D
3.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55606
4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
55475A
5.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55474C
6.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55403C
7.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55449C
8.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
10.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).