Use the same procedures for the RH and LH.
The procedures listed below are the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55449C
2.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55403C
3.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55474C
4.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55475A
5.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55606
6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
55432D
7.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55446A
8.REMOVE NO. 1 SWITCH HOLE BASE
9.REMOVE CURTAIN SHIELD AIRBAG CUTOFF SWITCH
Detach the 2 claws and remove the switch.