Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM › from 2015.08
RM2660E _58 Vehicle Interior _052845 SEAT _0255627 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C0  Front Right Seat Heat Sensor Circuit  


DESCRIPTION

Output to the front seat cushion heater assembly RH temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC Code DTC Detection Condition Trouble Area
B14C0 Seat heater temperature sensor malfunction
·

Air conditioning amplifier assembly

·

Front seat cushion heater assembly RH

·

Seat heater control sub-assembly RH

·

Wire harness or connector



WIRING DIAGRAM

B377738E36
3.521,0.385 3.979,0.583 0.458,0.198 10 false THR 5.375,0.469 5.833,0.667 0.458,0.198 10 false TSR 5.063,0.354 5.615,0.552 0.552,0.198 10 false 20 3.99,0.469 4.448,0.667 0.458,0.198 10 false c1 3.99,0.26 4.448,0.458 0.458,0.198 10 false 5 5.375,0.938 5.833,1.135 0.458,0.198 10 false SG-4 4.917,1.49 5.375,1.688 0.458,0.198 10 false E35 5.083,0.813 5.615,1.021 0.531,0.208 10 false 34 3.604,0.844 4.063,1.042 0.458,0.198 10 false PR 3.979,0.927 4.438,1.125 0.458,0.198 10 false c1 3.99,0.719 4.448,0.917 0.458,0.198 10 false 2 2.917,0.385 3.375,0.583 0.458,0.198 10 false TH1 2.927,0.833 3.385,1.031 0.458,0.198 10 false TH2 2.521,0.469 2.979,0.667 0.458,0.198 10 false SHR 2.625,0.26 3.083,0.458 0.458,0.198 10 false 2 2.521,0.927 2.979,1.125 0.458,0.198 10 false SHR 2.625,0.719 3.083,0.917 0.458,0.198 10 false 3 4.917,1.656 6.49,2.146 1.573,0.49 10 false Air Conditioning Amplifier Assembly 2.719,1.313 3.99,1.708 1.271,0.396 10 false Seat Heater Control Sub-assembly RH 0.865,1.323 2.49,1.75 1.625,0.427 10 false Front Cushion Heater Assembly RH

PROCEDURE

1.CLEAR DTC

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Vehicle Interior>SEAT>SEAT HEATER SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B14C0 is not output.




OK

NG

3.READ VALUE USING GTS (FR SEAT HEATER TEMPERATURE)
3.READ VALUE USING GTS (FR SEAT HEATER TEMPERATURE)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


e.

Read the Data List according to the display on the GTS.

Air Conditioner
Tester Display Measurement Item/Display Range Normal Condition Diagnostic Note
FR Seat Heater Temperature Front seat RH heater temperature -29.7°C to 59.55°C Within range from 32 to 43°C (89 to 109°F) Front seat heater is on



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH
4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH
a.

Remove the front seat cushion heater assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT CUSHION HEATER>REMOVAL).


b.

Inspect the front seat cushion heater assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT CUSHION HEATER>INSPECTION).



OK

5.INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY RH

NG

REPLACE FRONT SEAT CUSHION HEATER ASSEMBLY RH

5.INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY RH
a.

Remove the seat heater control sub-assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY).


U164353E01
2.08,3.126 2.510,3.292 0.430,0.165 10 TH1 0.77,3.126 1.200,3.292 0.430,0.165 10 TH2 2.09,1.345 2.538,1.552 0.448,0.208 10 THR 0.053,0.017 0.362,0.182 0.310,0.165 10 *a 0.053,1.616 0.362,1.781 0.310,0.165 10 *b 0.508,0.249 0.818,0.414 0.310,0.165 10 PR 2.045,1.437 1.894,1.437 1.894,1.437 1.639,1.082 false 2.027,3.21 1.894,3.21 1.894,3.21 1.684,2.797 false 1.157,3.21 1.249,3.21 1.249,3.21 1.352,2.797 false 0.848,0.355 0.974,0.355 0.974,0.355 1.37,0.733 false 1.602,0.082 1.998,0.287 0.397,0.205 10 c1 1.533,1.62 1.964,1.831 0.431,0.211 10 SHR

b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
c1-5 (THR) - SHR-2 (TH1) Always Below 1 Ω
c1-2 (PR) - SHR-3 (TH2) Always Below 1 Ω
c1-5 (THR) or SHR-2 (TH1) - Body ground Always 10 kΩ or higher
c1-2 (PR) or SHR-3 (TH2) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Seat Heater Control Sub-assembly RH
(to Air Conditioning Amplifier Assembly)
*b Seat Heater Control Sub-assembly RH
(to Front Seat Cushion Heater Assembly RH)



OK

6.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY RH)

NG

REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY RH

6.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY RH)
a.

Disconnect the E35 air conditioning amplifier assembly connector.


b.

Disconnect the c1 seat heater control sub-assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
c1-5 (THR) - E35-34 (SG-4) Always Below 1 Ω
c1-5 (THR) or E35-34 (SG-4) - Body ground Always 10 kΩ or higher
c1-5 (THR) - E35-34 (TSR) Always Below 1 Ω
c1-5 (THR) or E35-34 (TSR) - Body ground Always 10 kΩ or higher




OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR