Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM › from 2015.08
RM2660E _58 Vehicle Interior _052845 SEAT _0255627 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C1  Front Left Seat Heat Sensor Circuit  


DESCRIPTION

Output to the front seat cushion heater assembly LH temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC Code DTC Detection Condition Trouble Area
B14C1 Seat heater temperature sensor malfunction
·

Air conditioning amplifier assembly

·

Front seat cushion heater assembly LH

·

Seat heater control sub-assembly LH

·

Wire harness or connector



WIRING DIAGRAM

B377738E37
3.521,0.385 3.979,0.583 0.458,0.198 10 false THL 5.344,0.469 5.802,0.667 0.458,0.198 10 false TSL 5.073,0.333 5.531,0.531 0.458,0.198 10 false 19 3.927,0.458 4.385,0.656 0.458,0.198 10 false c13 3.99,0.25 4.448,0.448 0.458,0.198 10 false 5 5.344,0.938 5.802,1.135 0.458,0.198 10 false SG-4 5.052,0.802 5.51,1 0.458,0.198 10 false 34 3.604,0.844 4.063,1.042 0.458,0.198 10 false PL 3.938,0.927 4.396,1.125 0.458,0.198 10 false c13 3.99,0.719 4.448,0.917 0.458,0.198 10 false 2 2.917,0.385 3.375,0.583 0.458,0.198 10 false TH1 2.927,0.833 3.385,1.031 0.458,0.198 10 false TH2 2.542,0.469 3,0.667 0.458,0.198 10 false SHL 2.615,0.26 3.073,0.458 0.458,0.198 10 false 2 2.542,0.927 3,1.125 0.458,0.198 10 false SHL 2.625,0.719 3.083,0.917 0.458,0.198 10 false 3 5.052,1.75 6.625,2.24 1.573,0.49 10 false Air Conditioning Amplifier Assembly 2.792,1.313 4.063,1.708 1.271,0.396 10 false Seat Heater Control Sub-assembly LH 0.917,1.313 2.542,1.74 1.625,0.427 10 false Front Cushion Heater Assembly LH 5.052,1.594 5.51,1.792 0.458,0.198 10 false E35

PROCEDURE

1.CLEAR DTC

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Vehicle Interior>SEAT>SEAT HEATER SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B14C1 is not output.




OK

NG

3.READ VALUE USING GTS (FL SEAT HEATER TEMPERATURE)
3.READ VALUE USING GTS (FL SEAT HEATER TEMPERATURE)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


e.

Read the Data List according to the display on the GTS.

Air Conditioner
Tester Display Measurement Item/Display Range Normal Condition Diagnostic Note
FL Seat Heater Temperature Front seat LH heater temperature -29.7°C to 59.55°C Within range from 32 to 43°C (89 to 109°F) Front seat heater is on



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
a.

Remove the front seat cushion heater assembly LH (See pageVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER>REMOVAL).


b.

Inspect the front seat cushion heater assembly LH (See page Vehicle Interior>SEAT>FRONT SEAT CUSHION HEATER>INSPECTION).



OK

5.INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH

NG

REPLACE FRONT SEAT CUSHION HEATER ASSEMBLY LH

5.INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH
a.
U164354E01
2.08,3.126 2.510,3.292 0.430,0.165 10 TH1 0.77,3.126 1.200,3.292 0.430,0.165 10 TH2 2.09,1.345 2.538,1.552 0.448,0.208 10 THL 0.053,0.017 0.362,0.182 0.310,0.165 10 *a 0.053,1.616 0.362,1.781 0.310,0.165 10 *b 0.508,0.249 0.818,0.414 0.310,0.165 10 PL 2.045,1.437 1.894,1.437 1.894,1.437 1.639,1.082 false 2.027,3.21 1.894,3.21 1.894,3.21 1.684,2.797 false 1.157,3.21 1.249,3.21 1.249,3.21 1.352,2.797 false 0.848,0.355 0.974,0.355 0.974,0.355 1.37,0.733 false 1.567,0.082 1.964,0.287 0.397,0.205 10 c13 1.533,1.62 1.964,1.831 0.431,0.211 10 SHL

Remove the seat heater control sub-assembly LH connector (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
c13-5 (THL) - SHL-2 (TH1) Always Below 1 Ω
c13-2 (PL) - SHL-3 (TH2) Always Below 1 Ω
c13-5 (THL) or SHL-2 (TH1) - Body ground Always 10 kΩ or higher
c13-2 (PL) or SHL-3 (TH2) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Seat Heater Control Sub-assembly LH
(to Air Conditioning Amplifier Assembly)
*b Seat Heater Control Sub-assembly LH
(to Front Seat Cushion Heater Assembly LH)



OK

6.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY LH)

NG

REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY LH

6.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY LH)
a.

Disconnect the E35 air conditioning amplifier assembly connector.


b.

Disconnect the c13 seat heater control sub-assembly LH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
c13-5 (THL) - E35-19 (TSL) Always Below 1 Ω
c13-5 (THL) or E35-19 (TSL) - Body ground Always 10 kΩ or higher
c13-2 (PL) - E35-34 (SG-4) Always Below 1 Ω
c13-2 (PL) or SHL-3 (TH2) - Body ground Always 10 kΩ or higher




OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR