Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
72760D
1.INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH
Install the lumbar support adjuster assembly LH with the 2 screws.
Connect the connector.
Attach the 4 hooks to install the seatback spring.
| *1 | Cable Clamp |
| *2 | Hook |
Install the 4 springs.
Connect the active headrest cable to the seatback spring with the cable clamp.
2.INSTALL FRONT SEATBACK PROTECTOR
3.INSTALL SEATBACK COVER WITH PAD
Attach the hooks to install the seatback cover with pad.
| *1 | Hog Ring |
| *2 | Hog Ring Pliers |
Attach the seatback cover bracket with the nut.
| *1 | Seatback Cover Bracket |
After the seatback cover with pad is installed, make sure the seatback cover bracket is not twisted.
Using hog ring pliers, install new hog rings.
Be careful not to damage the cover.
w/o Climate Control Seat System:
Connect the connector and attach the 2 wire harness clamps.
w/ Climate Control Seat System:
Connect the 2 connectors and attach the 4 wire harness clamps.
71931
4.INSTALL FRONT SEAT HEADREST SUPPORT
85865
5.INSTALL SEAT CLIMATE CONTROL CONTROLLER LH
86295E
6.INSTALL NO. 2 TELEVISION BASE
71706
7.INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH
86680A
8.INSTALL TELEVISION DISPLAY ASSEMBLY
86295
9.INSTALL TELEVISION BASE
71862
10.INSTALL FRONT INNER SEAT CUSHION SHIELD LH
73240
11.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
71812D
12.INSTALL FRONT SEAT CUSHION SHIELD LH
84921A
13.INSTALL RECLINING POWER SEAT SWITCH KNOB
84921B
14.INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
71200S
15.INSTALL FRONT SEAT ASSEMBLY LH