Use the same procedures for the LHD and RHD.
The procedures listed below are for the LHD.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73320A
1.CONNECT NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH
Connect the belt anchor.
Do not overlap the anchor part of the seat belt and protruding parts of the vehicle body.
73390C
2.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
Install the belt with the bolt.
Do not overlap the anchor part of the seat belt and protruding parts of the vehicle body.
The No. 1 seat 3 point type belt anchor is fixed with the same bolt as the rear No. 1 seat inner belt LH. Therefore, connect it when installing the rear No. 1 seat inner belt LH.
78956
3.INSTALL REAR SEAT UNDER TRAY COVER LH
72995
4.INSTALL REAR SEAT CUSHION COVER RH
76974E
5.INSTALL REAR UNDER SIDE COVER LH
71369B
6.INSTALL REAR SEATBACK STAY COVER LH
73178B
7.INSTALL SEAT BELT ANCHOR COVER CAP
71301B
8.INSTALL REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
71302B
9.INSTALL REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
71469
10.INSTALL REAR NO. 2 SEAT PROTECTOR
79965
11.INSTALL REAR NO. 2 SEAT LEG SIDE COVER
72265
12.INSTALL UPPER SEAT TRACK RAIL COVER RH
72266
13.INSTALL UPPER SEAT TRACK RAIL COVER LH
71833A
14.INSTALL REAR NO. 1 SEAT RECLINING COVER RH
71834G
15.INSTALL REAR NO. 1 SEAT RECLINING COVER LH
72526A
16.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
72329
17.INSTALL SEAT ADJUSTER BOLT COVER
18.INSTALL REAR NO. 1 SEAT ASSEMBLY LH
Install the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Seat Type 60 Side)>INSTALLATION).