Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73570
1.INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH
Align the claws with the seat belt positioning holes and install the retractor of the seat belt as shown in the illustration.
Install the seat belt with the bolt.
Install the seat belt shoulder anchor with the bolt.
Attach the 2 claws to close the seat belt shoulder anchor cover.
62520P
2.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH
When installing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.
w/o Rear Air Conditioning System:
Connect the rear seat lock control lever cable.
w/ Rear Air Conditioning System:
Connect the thermistor connector and rear seat lock control lever cable.
Attach the 18 clips and 2 claws to install the quarter trim panel.
Install the clip and bolt.
for LH Side:
Install the rear No. 2 seat belt anchor LH with the bolt.
Do not overlap the anchor part of the seat belt and protruding parts of the vehicle body.
for RH Side:
Install the rear No. 2 seat belt anchor RH with the bolt.
Attach the 3 claws to install the cover.
Install the rear No. 1 seat belt anchor with the bolt.
Attach the 3 claws to install the cover.
71866B
3.INSTALL REAR NO. 2 SEAT COVER BEZEL
67918E
4.INSTALL REAR DOOR SCUFF PLATE LH
51775
5.INSTALL REAR STEP COVER
58574A
6.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
7.INSTALL REAR NO. 2 SEAT ASSEMBLY
Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>INSTALLATION).