Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) › from 2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255699 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  B1411/11  Room Temperature Sensor Circuit  


DESCRIPTION

The front room temperature sensor for the front seat is installed in the instrument panel to detect the room temperature and control the heater and air conditioner "auto" mode. The resistance of the room temperature sensor changes in accordance with the front room temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.

The air conditioning amplifier assembly applies voltage (5 V) to the front room temperature sensor and reads voltage changes as the resistance of the front room temperature sensor changes. This sensor also sends the appropriate signals to the air conditioning amplifier assembly.

DTC Code DTC Detection Condition Trouble Area
B1411/11 An open or short in the front room temperature sensor circuit.
·

Cooler thermistor (room temperature sensor)

·

Harness or connector

·

Air conditioning amplifier assembly



WIRING DIAGRAM

w/ Rear Heater:


E312530E64
4.542,1.604 5,1.802 0.458,0.198 10 false E35 4.542,1.781 6.896,2.104 2.354,0.323 10 false Air Conditioning Amplifier Assembly 4.802,0.521 5.26,0.719 0.458,0.198 10 false TR 4.802,1 5.26,1.198 0.458,0.198 10 false SG-1 4.542,1.01 4.729,1.24 0.188,0.229 10 false 1 4.5,0.51 4.802,0.729 0.302,0.219 10 false 16 2.99,0.521 3.406,0.688 0.417,0.167 10 false 1 3,1.01 3.417,1.177 0.417,0.167 10 false 2 0.521,1.542 0.979,1.74 0.458,0.198 10 false E32 0.521,1.729 3.5,2 2.979,0.271 10 false Cooler Thermistor (Room Temperature Sensor) 5.708,0.208 6.167,0.406 0.458,0.198 10 false 5 V 6.167,0.635 6.625,0.833 0.458,0.198 10 false IC


w/o Rear Heater:


E312530E65
4.542,1.625 5,1.823 0.458,0.198 10 false E165 4.563,1.802 6.917,2.125 2.354,0.323 10 false Air Conditioning Amplifier Assembly 4.813,0.51 5.271,0.708 0.458,0.198 10 false TR 4.813,1 5.271,1.198 0.458,0.198 10 false SG-1 4.552,1.01 4.76,1.198 0.208,0.188 10 false 8 4.542,0.521 4.698,0.729 0.156,0.208 10 false 4 2.99,0.531 3.406,0.698 0.417,0.167 10 false 1 3,1.01 3.417,1.177 0.417,0.167 10 false 2 0.479,1.51 0.938,1.708 0.458,0.198 10 false E32 0.479,1.698 3.469,1.948 2.99,0.25 10 false Cooler Thermistor (Room Temperature Sensor) 5.708,0.198 6.167,0.396 0.458,0.198 10 false 5 V 6.156,0.635 6.615,0.833 0.458,0.198 10 false IC


PROCEDURE

1.READ VALUE USING GTS (ROOM TEMPERATURE SENSOR)
a.

Use the Data List to check if the cooler thermistor (room temperature sensor) is functioning properly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DATA LIST / ACTIVE TEST).

Air Conditioner
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Room Temperature Sensor Cooler thermistor (room temperature sensor) / Min.: -6.5°C (20.3°F), Max.: 57.25°C (135.05°F) Actual room temperature for front seat displayed Cooler thermistor (room temperature sensor) system malfunction:
·

pen in the circuit: -6.5°C (20.3°F)O

·

Short in the circuit: 57.25°C (135.05°F)



OK:

The display is as specified in the normal condition.


Result
Result Proceed to
OK (When troubleshooting according to the DTC) A
OK (When troubleshooting according to Problem Symptoms Table) B
NG C



A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B

C

2.INSPECT COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)
2.INSPECT COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)
a.

Remove the cooler thermistor (room temperature sensor) (See page Vehicle Interior>HEATING / AIR CONDITIONING>ROOM TEMPERATURE SENSOR(for Front Side)>REMOVAL).


b.

Inspect the cooler thermistor (room temperature sensor) (See page Vehicle Interior>HEATING / AIR CONDITIONING>ROOM TEMPERATURE SENSOR(for Front Side)>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (COOLER THERMISTOR [ROOM TEMPERATURE SENSOR] - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPLACE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)

3.CHECK HARNESS AND CONNECTOR (COOLER THERMISTOR [ROOM TEMPERATURE SENSOR] - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.

w/ Rear Heater:

i.

Disconnect the E32 cooler thermistor (room temperature sensor) connector.


ii.

Disconnect the E35 air conditioning amplifier assembly connector.


iii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E32-1 - E35-16 (TR) Always Below 1 Ω
E32-2 - E35-1 (SG-1) Always Below 1 Ω
E32-1 - E32-2 Always 10 kΩ or higher
E32-1 or E35-16 (TR) - Body ground Always 10 kΩ or higher
E32-2 or E35-1 (SG-1) - Body ground Always Below 1 Ω




b.

w/o Rear Heater:

i.

Disconnect the E32 cooler thermistor (room temperature sensor) connector.


ii.

Disconnect the E165 air conditioning amplifier assembly connector.


iii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E32-1 - E165-4 (TR) Always Below 1 Ω
E32-2 - E165-8 (SG-1) Always Below 1 Ω
E32-1 - E32-2 Always 10 kΩ or higher
E32-1 or E165-4 (TR) - Body ground Always 10 kΩ or higher
E32-2 or E165-8 (SG-1) - Body ground Always Below 1 Ω





OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR