The rear air outlet damper servo motor sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the rear air outlet damper to the appropriate position, which controls the air outlet modes.
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1449/49 | The rear air outlet damper position does not change even if the air conditioning amplifier assembly operates the rear air outlet damper servo motor. | ·
Rear air outlet damper servo motor ·
No. 2 air conditioning harness assembly ·
Harness or connector between No. 2 air conditioning harness assembly and air conditioning amplifier assembly ·
Air conditioning amplifier assembly |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Air Outlet Servo Pulse (R) | Rear air outlet damper servo motor target pulse /
Min.: 7, Max.: 83 |
Foot: 7 (pulse)
B/L: 42 (pulse) FACE: 83 (pulse) |
- |
The display is as specified in the normal condition.
| Result | Proceed to |
|---|---|
| OK (Checking from the DTC) | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| NG | C |
A
B
C
Disconnect the K19 No. 2 air conditioning harness assembly connector.
Disconnect the E36 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K19-2 (RBUG) - E36-12 (RBUG) | Always | Below 1 Ω |
| K19-3 (RBUS) - E36-13 (RBUS) | ||
| K19-4 (RBBU) - E36-14 (RBBU) | ||
| E36-12 (RBUG) - Body ground | Always | 10 kΩ or higher |
| E36-13 (RBUS) - Body ground | ||
| E36-14 (RBBU) - Body ground |
OK
NG
Replace the rear air outlet damper servo motor (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT (w/ Heater)>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1449/49 is not output | A |
| DTC B1449/49 is output | B |
A
B
Replace the No. 2 air conditioning harness assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT (w/ Heater)>DISASSEMBLY).
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1449/49 is not output | A |
| DTC B1449/49 is output | B |
A
B