Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) › from 2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255699 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  B1429/29  Rear Air Foot Duct Sensor Circuit on Front Passenger Side  


DESCRIPTION

1: for LHD

2: for RHD


The cooler thermistor (duct sensor RH*1 or LH*2) detects the duct temperature and sends the appropriate signals to the air conditioning amplifier assembly.

DTC Code DTC Detection Condition Trouble Area
B1429/29 An open or short in the air duct temperature sensor RH*1 or LH*2 circuit.
·

Cooler thermistor (duct sensor RH)*1

·

Cooler thermistor (duct sensor LH)*2

·

Harness or connector

·

Air conditioning amplifier assembly



WIRING DIAGRAM

for LHD:


E312530E71
4.542,1.604 5,1.802 0.458,0.198 10 false E35 4.552,1.792 6.906,2.115 2.354,0.323 10 false Air Conditioning Amplifier Assembly 4.792,0.542 5.25,0.74 0.458,0.198 10 false RHTR 4.813,1.021 5.271,1.219 0.458,0.198 10 false SGND 4.479,1.021 4.896,1.188 0.417,0.167 10 false 31 4.49,0.531 4.906,0.698 0.417,0.167 10 false 17 2.99,0.531 3.406,0.698 0.417,0.167 10 false 1 3,1.01 3.417,1.177 0.417,0.167 10 false 2 0.583,1.5 1.042,1.698 0.458,0.198 10 false L12 0.583,1.667 2.885,1.906 2.302,0.24 10 false Cooler Thermistor (Duct Sensor RH) 5.698,0.198 6.156,0.396 0.458,0.198 10 false 5 V 6.188,0.625 6.646,0.823 0.458,0.198 10 false IC


for RHD:


E312530E72
4.542,1.625 5,1.823 0.458,0.198 10 false E35 4.542,1.781 6.896,2.104 2.354,0.323 10 false Air Conditioning Amplifier Assembly 4.781,0.531 5.24,0.729 0.458,0.198 10 false RHTL 4.792,1 5.25,1.198 0.458,0.198 10 false SGND 4.51,1.01 4.927,1.177 0.417,0.167 10 false 31 4.5,0.521 4.917,0.688 0.417,0.167 10 false 18 2.99,0.531 3.406,0.698 0.417,0.167 10 false 1 3,1.01 3.417,1.177 0.417,0.167 10 false 2 0.688,1.521 1.146,1.719 0.458,0.198 10 false K21 0.688,1.708 2.948,1.979 2.26,0.271 10 false Cooler Thermistor (Duct Sensor LH) 6.167,0.646 6.625,0.844 0.458,0.198 10 false IC 5.708,0.219 6.167,0.417 0.458,0.198 10 false 5 V


PROCEDURE

1.READ VALUE USING GTS (FOOT DUCT SENSOR [REAR P])

*1: for LHD

*2: for RHD


a.

Use the Data List to check if the cooler thermistor (duct temperature sensor RH*1 or LH*2) is functioning properly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).

Air Conditioner
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Foot Duct Sensor (Rear P) Cooler thermistor (duct sensor RH*1 or LH*2) / Min.: -12.7°C (9.14°F), Max.: 76.55°C (169.79°F) Actual cooler thermistor (duct sensor RH*1 or LH*2) displayed Cooler thermistor (duct sensor RH*1 or LH*2) system malfunction:
·

Open in the circuit: -12.7°C (9.14°F)

·

Short in the circuit: 76.55°C (169.79°F)



OK:

The display is as specified in the normal condition.


Result
Result Proceed to
OK (When troubleshooting according to the DTC) A
OK (When troubleshooting according to Problem Symptoms Table) B
NG C



A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B

C

2.INSPECT COOLER THERMISTOR (DUCT SENSOR)
2.INSPECT COOLER THERMISTOR (DUCT SENSOR)

*1: for LHD

*2: for RHD


a.

Remove the cooler thermistor (duct sensor RH*1 or LH*2) (See page Vehicle Interior>HEATING / AIR CONDITIONING>DUCT TEMPERATURE SENSOR (w/ Heater)>REMOVAL).


b.

Inspect the the cooler thermistor (duct sensor RH*1 or LH*2) (See page Vehicle Interior>HEATING / AIR CONDITIONING>DUCT TEMPERATURE SENSOR (w/ Heater)>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - COOLER THERMISTOR [DUCT SENSOR])

NG

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - COOLER THERMISTOR [DUCT SENSOR])
a.

Disconnect the E35 air conditioning amplifier assembly connector.


b.

for LHD:

i.

Disconnect the L12 cooler thermistor (duct sensor RH) connector.



c.

for RHD:

i.

Disconnect the K21 cooler thermistor (duct sensor LH) connector.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD::
Tester Connection Condition Specified Condition
E35-17 (RHTR) - L12-1 Always Below 1 Ω
E35-31 (SGND) - L12-2 (-) Always Below 1 Ω
L12-1 - L12-2 Always 10 kΩ or higher
E35-17 (RHTR) or L12-1 - Body ground Always 10 kΩ or higher
E35-31 (SGND) or L12-2 - Body ground Always 10 kΩ or higher

for RHD::
Tester Connection Condition Specified Condition
E35-18 (RHTL) - K21-1 Always Below 1 Ω
E35-31 (SGND) - K21-2 Always Below 1 Ω
K21-1 - K21-2 Always 10 kΩ or higher
E35-18 (RHTL) or K21-1 - Body ground Always 10 kΩ or higher
E35-31 (SGND) or K21-2 - Body ground Always 10 kΩ or higher




OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR