The rear air mix damper servo motor (for driver side) sends pulse signals to indicate the damper position to the air conditioning amplifier assembly. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the rear air mix damper to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1447/47 | The rear air mix damper position does not change even if the air conditioning amplifier assembly operates the rear air mix damper servo motor. | ·
Rear air mix damper servo motor ·
No. 2 air conditioning harness assembly ·
Wire harness between No. 2 air conditioning harness assembly and air conditioning amplifier assembly ·
Air conditioning amplifier assembly |
Use the Data List to check if the servo motor is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| A/M Servo Targ Pulse (Rear D) | Rear air mix damper servo motor target pulse /
Min.: 9, Max.: 54 (for LHD) Min.: 8, Max.: 53 (for RHD) |
for LHD
·
MAX COOL: 9 (pulse) ·
MAX HOT: 54 (pulse) for RHD ·
MAX COOL: 53 (pulse) ·
MAX HOT: 8 (pulse) |
- |
The display is as specified in the normal condition.
| Result | Proceed to |
|---|---|
| OK (Checking from the DTC) | A |
| OK (Checking from the PROBLEM SYMPTOMS TABLE) | B |
| NG | C |
A
B
C
Disconnect the K19 No. 2 air conditioning harness connector.
Disconnect the E36 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K19-2 (RBUG) - E36-12 (RBUG) | Always | Below 1 Ω |
| K19-3 (RBUS) - E36-13 (RBUS) | ||
| K19-4 (RBBU) - E36-14 (RBBU) | ||
| E36-12 (RBUG) - Body ground | Always | 10 kΩ or higher |
| E36-13 (RBUS) - Body ground | ||
| E36-14 (RBBU) - Body ground |
OK
NG
Replace the rear air mix damper servo motor (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT (w/ Heater)>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1447/47 is not output | A |
| DTC B1447/47 is output | B |
A
B
Replace the No. 2 air conditioning harness assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT (w/ Heater)>DISASSEMBLY).
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1447/47 is not output | A |
| DTC B1447/47 is output | B |
A
B