The cooler expansion valve (cooler magnetic valve) is controlled by the air conditioning amplifier assembly (for cool box).
Remove the A/C IG fuse from the cowl side junction block LH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A/C IG fuse | Always | Below 1 Ω |
OK
NG
Disconnect the No. 1 cooler wiring harness sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (B) - Body ground | Engine switch off | Below 1 V |
| Engine switch on (IG) | 11 to 14 V |
OK
NG
Disconnect the No. 1 cooler wiring harness sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (L) - Body ground | Always | Below 1 Ω |
OK
NG
Replace the No. 1 cooler wiring harness sub-assembly with a normal one and check that the condition returns to normal.
Same problem does not occur.
OK
NG
Replace the cooler magnetic valve (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>DISASSEMBLY).
Since the cooler magnetic valve cannot be inspected while it is removed from the vehicle, replace the cooler magnetic valve with a normal one and check that the condition returns to normal.
Same problem does not occur.
OK
NG