The cooler control switch sub-assembly is the activation switch for the cool box. If the cool box does not activate when the cooler control switch is pushed, there may be a malfunction in the circuit shown below.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the No. 1 cooler wiring harness sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 - Body ground | Always | 11 to 14 V |
| 1 - Body ground | Ignition switch off | Below 1 V |
| 1 - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to No. 1 Cooler Wiring Harness Sub-assembly) |
OK
NG
Disconnect the No. 1 cooler wiring harness sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to No. 1 Cooler Wiring Harness Sub-assembly) |
OK
NG
Replace the No. 1 cooler wiring harness sub-assembly with a new or known good one.
Same problem does not occur.
OK
NG
Remove the cooler control switch sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>DISASSEMBLY).
Inspect the cooler control switch sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>INSPECTION).
OK
NG