Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PANEL (w/ Navigation System) › from 2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255706 AIR CONDITIONING PANEL(w/ Navigation System) A

HEATING / AIR CONDITIONING  AIR CONDITIONING PANEL(w/ Navigation System)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for LHD and RHD vehicles.

·

The procedures listed below are for LHD vehicles.



PROCEDURE

Hide 86130A 1.INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY

a.

Connect the connectors.


b.

Insert the multi-media module receiver assembly and attach the 5 claws on its backside.

NOTICE:

When inserting the multi-media module receiver assembly, do not press the knobs on it.



c.

Install the multi-media module receiver assembly with the 2 bolts and 2 screws.

Torque:
for Bolt : 8.5 N*m (87 kgf*cm, 75 in.*lbf)


Hide 55406B 2.INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55402C 3.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55448A 4.INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55403C 5.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55449C 6.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55680A 8.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55670 9.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55510F 10.INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).