Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)
RM2660E _59 Vehicle Exterior _052850 WINDOW / GLASS _0255725 POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)  Rear Power Window RH does not Operate with Rear Power Window Switch RH  


DESCRIPTION

If the manual up/down function does not operate, there may be a malfunction in the rear power window regulator switch, rear power window regulator motor RH, harness or connector.


WIRING DIAGRAM

B184409E03
2.385,0.776 3.733,0.956 1.349,0.180 10 from Main Body ECU 5.499,2.666 6.003,2.836 0.504,0.170 10 DOWN 3.667,2.666 4.129,2.836 0.461,0.170 10 DOWN 5.499,3.139 5.905,3.308 0.406,0.170 10 AUTO 5.499,2.225 5.780,2.395 0.281,0.170 10 UP 5.504,1.121 5.841,1.291 0.338,0.170 10 B 5.249,0.983 5.367,1.153 0.118,0.170 10 2 5.249,1.397 5.367,1.567 0.118,0.170 10 1 5.249,2.564 5.367,2.734 0.118,0.170 10 7 5.249,3.027 5.367,3.197 0.118,0.170 10 4 4.234,3.027 4.351,3.197 0.118,0.170 10 8 2.942,3.161 3.060,3.331 0.118,0.170 10 1 2.768,3.624 2.940,3.794 0.172,0.170 10 J3 4.973,3.624 5.145,3.794 0.172,0.170 10 J4 4.234,2.546 4.351,2.716 0.118,0.170 10 7 4.234,2.119 4.351,2.289 0.118,0.170 10 6 5.225,2.119 5.409,2.289 0.184,0.170 10 10 5.504,1.518 5.841,1.688 0.338,0.170 10 GND 0.67,4.264 1.652,4.434 0.982,0.170 10 : LIN Line 3.187,3.272 3.530,3.442 0.343,0.170 10 GND 3.715,3.139 4.135,3.309 0.420,0.170 10 AUTO 3.921,2.225 4.143,2.395 0.222,0.170 10 UP 2.784,3.818 4.741,4.231 1.957,0.413 10 Rear Power Window Regulator Switch Assembly RH 4.975,3.789 6.928,4.241 1.952,0.452 10 Rear Power Window Regulator Motor Assembly RH 0.707,1.081 1.516,1.261 0.809,0.180 10 from Battery 1.854,1.277 2.804,1.453 0.950,0.176 10 RR DOOR RH

PROCEDURE

1.CHECK LIN COMMUNICATION SYSTEM
a.

Check for LIN communication system DTCs related to the power window control system (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

OK:

LIN communication system DTCs are not output.




OK

2.CHECK FOR DTC (B2312)

NG

2.CHECK FOR DTC (B2312)

OK

3.READ VALUE USING INTELLIGENT TESTER (REAR POWER WINDOW REGULATOR MOTOR RH)

NG

3.READ VALUE USING INTELLIGENT TESTER (REAR POWER WINDOW REGULATOR MOTOR RH)
a.

Use the Data List to check if the power window regulator motor is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)>DATA LIST / ACTIVE TEST).

RR-Door Motor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RR Door P/W Up SW Rear power window RH manual up signal / ON or OFF ON: Rear power window RH manual up switch operated
OFF: Rear power window RH switch not operated
-
RR Door P/W Down SW Rear power window RH manual down signal / ON or OFF ON: Rear power window RH manual down switch operated
OFF: Rear power window RH switch not operated
-

OK:

The display changes according to operation of the rear power window switch RH.




OK

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

NG

4.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH RH - BODY GROUND)
4.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH RH - BODY GROUND)
a.
U164014E01
0.126,0.093 2.719,0.458 2.593,0.365 10 Front view of wire harness connector: (to Rear Power Window Regulator Switch) 0.869,1.704 1.046,1.863 0.176,0.159 10 J3 0.819,2.471 1.153,2.623 0.333,0.152 10 GND 1.149,2.471 1.491,2.151 false

Disconnect the J3 switch connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
J3-1 (GND) - Body ground Always Below 1 Ω




OK

5.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR MOTOR RH - BATTERY AND BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR MOTOR RH - BATTERY AND BODY GROUND)
a.
U156995E01
0.115,0.035 2.524,0.374 2.409,0.339 10 Front view of wire harness connector: (to Power Window Regulator Motor) 0.625,1.39 0.896,1.548 0.270,0.158 10 J11 0.765,2.023 1.122,2.207 0.357,0.184 10 GND 2.296,2.023 2.500,2.207 0.205,0.184 10 B 1.17,2.096 1.603,1.763 false 2.272,2.122 1.847,1.758 false

Disconnect the J4 motor connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
J4-2 (B) - Body ground Always 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
J4-1 (GND) - Body ground Always Below 1 Ω




OK

6.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH RH - REAR POWER WINDOW REGULATOR MOTOR RH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH RH - REAR POWER WINDOW REGULATOR MOTOR RH)
a.
U164017E01
0.161,2.078 2.635,2.453 2.474,0.374 10 Front view of wire harness connector: (to Power Window Regulator Motor) 0.161,0.032 2.726,0.407 2.565,0.374 10 Front view of wire harness connector: (to Rear Power Window Regulator Switch) 0.653,1.033 0.826,1.217 0.173,0.184 10 J3 0.687,3.197 0.860,3.381 0.173,0.184 10 J4 0.875,1.382 1.159,1.551 0.283,0.169 10 UP 2.343,1.207 2.820,1.399 0.477,0.192 10 DOWN 2.47,1.531 2.890,1.693 0.420,0.162 10 AUTO 1.136,1.481 1.605,1.665 false 1.861,1.688 2.343,1.296 false 2.025,1.787 2.444,1.611 false 2.338,3.662 2.621,3.831 0.283,0.169 10 UP 0.62,4.206 1.097,4.398 0.477,0.192 10 DOWN 0.711,3.526 1.131,3.688 0.420,0.162 10 AUTO 1.233,3.597 1.602,3.796 false 1.929,3.934 2.298,3.76 false 1.064,4.198 1.483,4.022 false

Disconnect the J3 switch connector.


b.

Disconnect the J4 motor connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
J3-6 (UP) - J4-10 (UP) Always Below 1 Ω
J3-7 (DOWN) - J4-7 (DOWN) Always Below 1 Ω
J3-8 (AUTO) - J4-4 (AUTO) Always Below 1 Ω
J3-6 (UP) or J4-10 (UP) - Body ground Always 10 kΩ or higher
J3-7 (DOWN) or J4-7 (DOWN) - Body ground Always 10 kΩ or higher
J3-8 (AUTO) or J4-4 (AUTO) - Body ground Always 10 kΩ or higher




OK

7.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
B184456E03
0.027,1.386 2.768,1.743 2.741,0.357 10 Component without harness connected: (Rear Power Window Regulator Switch RH) 2.58,3.099 2.815,3.269 0.235,0.170 10 UP 0.403,3.134 0.869,3.303 0.466,0.170 10 DOWN 2.535,2.291 2.890,2.461 0.355,0.170 10 GND 0.976,3.225 1.576,2.92 false 2.014,2.642 2.524,2.382 false 1.766,2.921 2.563,3.17 false

a.

Remove the rear power window regulator switch RH (See page Vehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
J3-6 (UP) - J3-1 (GND) Manual up operation Below 1 Ω
J3-7 (DOWN) - J3-1 (GND) Manual down operation Below 1 Ω




OK

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

NG

REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH