Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
85720D
1.INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Apply MP grease to the sliding and rotating areas of the regulator motor.
Using a T25 ''TORX'' driver, install the motor with the 3 screws.
A new front window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
69802
2.INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
68102
3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
4.INSTALL FRONT DOOR SERVICE HOLE COVER
86160
5.INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
67602
6.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
74646
7.INSTALL DOOR ASSIST GRIP COVER
74240A
8.INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY
69278B
9.INSTALL FRONT DOOR INSIDE HANDLE BEZEL
67492A
10.INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).