Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door) › from 2015.08
RM2660E _59 Vehicle Exterior _052850 WINDOW / GLASS _0255730 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 85720G 1.INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.

Apply MP grease to the sliding and rotating areas of the regulator motor.


b.

Using a T25 "TORX" driver, install the motor with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new rear window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 69804 2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68124C 4.INSTALL REAR DOOR QUARTER WINDOW GLASS

Hide 67408F 5.INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68152C 6.INSTALL REAR DOOR GLASS RUN

Hide 67842E 7.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 86160C 8.INSTALL REAR SPEAKER SET (w/ Rear Speaker)

Hide 68174A 9.INSTALL REAR INNER DOOR GLASS WEATHERSTRIP

Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74611C 11.INSTALL ASSIST GRIP COVER

Hide 74272A 12.INSTALL REAR DOOR UPPER ARMREST BASE PANEL

Hide 69278C 13.INSTALL REAR DOOR INSIDE HANDLE BEZEL

Hide 28800 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).