If the auto up/down function does not operate, the cause may be one or more of the following:
The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.
The master switch has a malfunction.
The Hall-IC in the driver side power window regulator motor has a malfunction.
There is an open or short in the wiring between the master switch and the driver side power window regulator motor.
Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| B2311 is output | B |
| B2312 is output | C |
| B2313 is output | D |
| LIN communication system DTCs are output | E |
A
B
C
D
E
(See pagePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Check that the driver side door power window moves when the manual up/down function of the multiplex network master switch is operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)>OPERATION CHECK).
Driver side door power window moves.
OK
NG
Use the Data List to check if the master switch is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D Door P/W Auto SW | Driver side power window auto up/down signal / ON or OFF | ON: Driver side power window auto up/down switch operated
OFF: Driver side power window switch not operated |
- |
The display changes according to operation of the multiplex network master switch.
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C