When the rear window defogger switch is turned on, a rear window defogger activation request signal is sent via the LIN communication line*1 or CAN communication line and *2 to the air conditioning amplifier assembly. Then the air conditioning amplifier assembly operates the rear window defogger. When the on signal from the switch is received, the defogger relay (DEFOG) is operated for 15 minutes. Also, if the off signal from the switch is received within 15 minutes, the defogger relay (DEFOG) operation is stopped.
*1: w/o Navigation System
*2: w/ Navigation System
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication and LIN communication malfunctions before troubleshooting this symptom.
Select the Active Test using the intelligent tester to generate a control command, and then check that the rear window defogger operates (See page Vehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Defogger Relay (Rear) | Rear window defogger relay operation | OFF or ON | - |
On intelligent tester screen, item changes between ON and OFF according to above chart.
| Result | Proceed to |
|---|---|
| OK (w/o Navigation System) | A |
| OK (w/ Navigation System) | B |
| NG | C |
A
B
C
Temporarily replace the air conditioning control assembly with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL (w/o Navigation System)>REMOVAL).
NEXT
Turn the ignition switch ON.
Check that pressing the defogger switch illuminates the indicator and warms the rear window surface.
Check that after approximately 15 minutes, the indicator light turns off and the rear window defogger deactivates.
Rear window defogger system functioning normally.
OK
NG
Check if the navigation system function properly (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
Navigation system function properly.
OK
NG
Temporarily replace the air conditioning amplifier assembly with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL).
NEXT
Turn the ignition switch ON.
Check that pressing the defogger switch illuminates the indicator and warms the rear window surface.
Check that after approximately 15 minutes, the indicator light turns off and the rear window defogger deactivates.
Rear window defogger system functioning normally.
OK
NG
Temporarily replace the multi-media module receiver assembly with a new or normally functioning one (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (w/ Multi-display)>REMOVAL).
NEXT
Turn the ignition switch ON.
Check that pressing the defogger switch illuminates the indicator and warms the rear window surface.
Check that after approximately 15 minutes, the indicator light turns off and the rear window defogger deactivates.
Rear window defogger system functioning normally.
OK
NG
Remove the defogger relay from the engine room junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 4 | Battery voltage is not applied to terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | 10 kΩ or higher | |
| 3 - 4 | Battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω |
| Result | Proceed to |
|---|---|
| OK (w/ Rear Heater) | A |
| OK (w/o Rear Heater) | B |
| NG | C |
A
B
C
Remove the defogger relay from the engine room relay block.
Disconnect the E36 air conditioning amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Defogger relay terminal 1 - Body ground | Ignition switch ON | 11 to 14 V |
| Defogger relay terminal 5 - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Defogger relay terminal 2 - E36-25 (RDEF) | Always | Below 1 Ω |
OK
NG
Disconnect the S20 and S21 defogger wire connectors.
Remove the defogger relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S17-1(B) - Defogger relay terminal 3 | Always | Below 1 Ω |
| S18-1(B) - Body ground | ||
| Defogger relay terminal 4 - Body ground | ||
| S17-1(B) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the S20 and S21 defogger wire connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| S17-1 (B) - S18-1 (E) | Ignition switch ON and defogger switch on | 10 kΩ or higher |
OK
NG
Remove the defogger relay from the engine room relay block.
Disconnect the E81 air conditioning amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Defogger relay terminal 1 - Body ground | Ignition switch ON | 11 to 14 V |
| Defogger relay terminal 5 - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Defogger relay terminal 2 - E81-38 (RDEF) | Always | Below 1 Ω |
OK
NG
Disconnect the S20 and S21 defogger wire connectors.
Remove the defogger relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S17-1(B) - Defogger relay terminal 3 | Always | Below 1 Ω |
| S18-1(B) - Body ground | ||
| Defogger relay terminal 4 - Body ground | ||
| S17-1(B) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the S20 and S21 defogger wire connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| S17-1 (B) - S18-1 (E) | Ignition switch ON and defogger switch on | 11 to 14 V |
OK
NG