Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255746 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

a.

Pass the cable into the engine room.


b.

Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.


c.

Pass the cable front side through the upper radiator support.


d.

Connect the clamps shown in the illustration.

B309368


Hide 53630 2.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

a.

Pass the cable into the engine room.


b.

Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.


c.

Pass the cable front side through the upper radiator support.


d.

Connect the clamps shown in the illustration.

B309369


Hide 53601 3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Connect the hood lock control cable and attach the 2 claws to install the hood lock lever.


Hide 53883F 4.INSTALL FRONT FENDER MAIN SEAL LH (for LHD)

a.

Attach the 3 clips to install the fender main seal.


Hide 53882H 5.INSTALL FRONT FENDER MAIN SEAL RH (for RHD)

a.

Attach the 3 clips to install the fender main seal.


Hide 53510 6.INSTALL HOOD LOCK ASSEMBLY

a.
B181067

Apply MP grease to the sliding areas of the lock.


b.

Connect the hood lock control cable.


c.

Install the hood lock.


d.

Install the 2 bolts and nut.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


e.

Connect the connector.


Hide 53579 7.INSTALL HOOD LOCK NUT CAP

a.
B188504E02
0.042,0.042 0.802,0.323 0.76,0.281 12 false for LHD: 0.042,2.427 0.802,2.708 0.76,0.281 12 false for RHD:

Install a new hood lock nut cap.


Hide 53629 8.INSTALL HOOD LOCK CONTROL CABLE COVER

a.

Attach the claw to install the cable cover.


b.

Install the 3 screws.


Hide 88211B 9.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

Hide 52049 11.INSTALL FRONT BUMPER WINCH COVER SUB-ASSEMBLY (w/ Winch)

Hide 53292A 12.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 88211B 13.ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)