Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(w/ Winch) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255829 FRONT BUMPER(w/ Winch) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(w/ Winch)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 52521 1.INSTALL FRONT UPPER CENTER BUMPER RETAINER

a.

Install the front upper center bumper retainer with the 3 bolts.


Hide 81110 3.INSTALL HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52116A 4.INSTALL FRONT BUMPER SIDE SUPPORT LH

a.

Attach the 3 clips to install the front bumper side support LH.


b.

Install the 2 screws.


Hide 52115A 5.INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure described for the LH side.


Hide 52113D 6.INSTALL FRONT BUMPER EXTENSION LH

a.

Install the front bumper extension LH with the 3 bolts.


Hide 52112D 7.INSTALL FRONT BUMPER EXTENSION RH

HINT:

Use the same procedure described for the LH side.


Hide 52119A 8.INSTALL FRONT BUMPER COVER

a.

w/ Fog Light:

Connect the No. 4 engine room wire connector.


b.

Connect the winch control wire connector and attach the 10 claws to install the front bumper cover.


c.

Install the 3 clips, 4 screws and 4 bolts.


d.

Using a T30 "TORX" socket, install the 6 screws.


Hide 53111 9.INSTALL RADIATOR GRILLE ASSEMBLY

Hide 52049 10.INSTALL FRONT BUMPER WINCH COVER SUB-ASSEMBLY

a.

Attach the 3 guides.


b.

Attach the 2 claws and front bumper winch cover sub-assembly.


Hide 53292A 11.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 53806 12.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

a.

Push in the clip to install the front fender splash shield sub-assembly LH.


b.

Install the 3 bolts and screw.


Hide 53805 13.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

a.

Push in the clip to install the front fender splash shield sub-assembly RH.


b.

Install the 3 bolts and 2 screws.


Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 16.ADJUST FOG LIGHT AIMING (w/ Fog Light)