77035
1.INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Connect the cable to the clamps shown in the illustration to install the cable.
77377
2.INSTALL FUEL FILLER OPENING LID LOCK RETAINER
Install the lock retainer and turn it clockwise as shown in the illustration.
Install the cable and turn it clockwise as shown in the illustration.
77306
3.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
Connect the fuel lid lock control cable to the fuel lid lock open lever.
Attach the 2 claws to install the fuel lid lock open lever.
62510P
4.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH
71865A
5.INSTALL NO. 1 REAR SEAT COVER BEZEL (w/ Rear No. 2 Seat)
64937A
6.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)
58574A
7.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
67917C
8.INSTALL REAR DOOR SCUFF PLATE RH
51775
9.INSTALL REAR STEP COVER
67913B
10.INSTALL FRONT DOOR SCUFF PLATE RH
62111C
11.INSTALL COWL SIDE TRIM BOARD RH
55317A
12.INSTALL INSTRUMENT SIDE PANEL RH
64910J
13.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).