Home › Vehicle Exterior › DOOR / HATCH › FUEL LID LOCK CONTROL CABLE ASSEMBLY (for RHD) › from 2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255753 FUEL LID LOCK CONTROL CABLE ASSEMBLY(for RHD) A

DOOR / HATCH  FUEL LID LOCK CONTROL CABLE ASSEMBLY(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 64910J 3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 64937A 10.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

Hide 71865A 11.REMOVE REAR NO. 1 SEAT COVER BEZEL (w/ Rear No. 2 Seat)

Hide 62510P 12.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

Hide 77377 13.REMOVE FUEL FILLER OPENING LID LOCK RETAINER

B181053

a.

Turn the cable counterclockwise and remove the cable from the retainer.


b.
B181054

Turn the lock retainer counterclockwise and remove the lock retainer.


Hide 77306 14.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY

a.
B181065

Detach the 2 claws.


b.

Disconnect the fuel lid lock control cable and remove the fuel lid lock open lever.


Hide 77035 15.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY

a.

Using a screwdriver, disconnect the clamps shown in the illustration.

HINT:

Tape the screwdriver tip before use.


B182555


b.

Remove the lock control cable.