The No. 2 main body ECU receives the close position switch signal from the lower tail gate lock assembly RH and detects the open/closed status of the lower tail gate. DTC B225A is stored when the No. 2 main body ECU receives a close position switch malfunction signal from the lower tail gate lock assembly RH.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B225A | A close position switch malfunction (open or short circuit) signal is received from the lower tail gate lock. | ·
Lower tail gate lock assembly RH ·
Harness or connector ·
No. 2 main body ECU |
Check the Data List for proper functioning of the close position switch (See page Vehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Position Switch RH | Close position switch RH signal / ON or OFF | ON: Lower tail gate closed
OFF: Lower tail gate open |
- |
The display is as specified in the normal condition.
OK
NG
Starting with the lower tail gate closed, open and close the lower tail gate 6 times.
Check for DTCs (See page Vehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DTC CHECK / CLEAR).
Clear the DTCs (See page Vehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DTC CHECK / CLEAR).
Starting with the lower tail gate closed, open and close the lower tail gate 6 times.
Recheck for DTCs (See page Vehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DTC CHECK / CLEAR).
DTC B225A is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Remove the lower tail gate lock assembly RH (See page Vehicle Exterior>DOOR / HATCH>BACK DOOR>DISASSEMBLY).
Inspect the lower tail gate lock assembly RH (See page Vehicle Exterior>DOOR / HATCH>BACK DOOR>INSPECTION).
OK
NG
Disconnect the h4 lower tail gate lock assembly RH connector.
Disconnect the L50 No. 2 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| h4-7 (HND) - L50-17 (LMT) | Always | Below 1 Ω |
| h4-8 (GND) - Body ground | Always | Below 1 Ω |
| h4-7 (HND) - Body ground | Always | 10 kΩ or higher |
OK
NG