Home › Vehicle Exterior › DOOR / HATCH › TAIL GATE CLOSER SYSTEM › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255760 TAIL GATE CLOSER SYSTEM C

DOOR / HATCH  TAIL GATE CLOSER SYSTEM  B225D  Tail Gate Panel Half Switch or Courtesy Switch LH  


DESCRIPTION

The No. 2 main body ECU receives the half-latch switch, pawl switch and lower tail gate courtesy switch signals from the lower tail gate lock assembly LH and detects the open/closed status of the lower tail gate. DTC B225D is stored when the No. 2 main body ECU receives a half-latch switch, pawl switch or lower tail gate courtesy switch malfunction signal from the lower tail gate lock assembly LH.

DTC Code DTC Detection Condition Trouble Area
B225D A half-latch switch, pawl switch or lower tail gate courtesy switch malfunction (open or short circuit) signal from the lower tail gate lock LH is received.
·

Lower tail gate lock assembly LH

·

Harness or connector

·

No. 2 main body ECU



WIRING DIAGRAM

B312265E02
5.49,2.146 5.74,2.292 0.25,0.146 10 false L51 5.615,2.792 7.01,2.938 1.396,0.146 10 false No. 2 Main Body ECU 1.021,2.792 2.417,2.938 1.396,0.146 10 false h5 1.021,2.958 3.219,3.104 2.198,0.146 10 false Lower Tail Gate Lock Assembly LH 5.49,1.177 5.74,1.323 0.25,0.146 10 false L51 5.49,0.365 5.74,0.51 0.25,0.146 10 false L50 5.563,1.99 5.656,2.135 0.094,0.146 10 false 4 5.563,1.021 5.667,1.167 0.104,0.146 10 false 9 5.521,0.198 5.698,0.344 0.177,0.146 10 false 15 5.813,2.156 6.104,2.302 0.292,0.146 10 false FUL 5.813,1.188 6.125,1.333 0.313,0.146 10 false HAF 5.813,0.375 6.115,0.521 0.302,0.146 10 false POL 3.708,2.052 3.958,2.198 0.25,0.146 10 false 2 3.708,1.083 3.958,1.229 0.25,0.146 10 false 1 3.708,0.26 3.958,0.406 0.25,0.146 10 false 4 3.333,2.25 3.625,2.396 0.292,0.146 10 false FUL 3.323,1.292 3.625,1.438 0.302,0.146 10 false HAF 3.313,0.469 3.625,0.615 0.313,0.146 10 false POL 1.177,2.302 3.229,2.448 2.052,0.146 10 false Lower Tail Gate Courtesy Switch 0.708,2.26 0.958,2.406 0.25,0.146 10 false E1 0.542,2.063 0.635,2.208 0.094,0.146 10 false 3 1.688,1.333 2.75,1.479 1.063,0.146 10 false Half-latch Switch 1.833,0.51 2.604,0.656 0.771,0.146 10 false Pawl Switch

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Check the Data List for proper functioning of the half-latch switch, pawl switch and lower tail gate courtesy switch (See page Vehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DATA LIST / ACTIVE TEST).

Body No. 4
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Half Latch Switch LH Half-latch switch signal / ON or OFF ON: Lower tail gate open
OFF: Lower tail gate closed
-
Courtesy Switch LH Lower tail gate courtesy switch LH signal / ON or OFF ON: Lower tail gate open
OFF: Lower tail gate closed
-
Luggage Pawl switch Pawl switch signal / ON or OFF ON: Lower tail gate lock motor operating
OFF: Lower tail gate open or closed
-

OK:

The display is as specified in the normal condition.




OK

2.CHECK DTC OUTPUT

NG

3.INSPECT LOWER TAIL GATE LOCK ASSEMBLY LH
2.CHECK DTC OUTPUT
a.

Starting with the lower tail gate closed, open and close the lower tail gate 6 times.




d.

Starting with the lower tail gate closed, open and close the lower tail gate 6 times.


e.

Recheck for DTCs (See page Vehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B225D is not output.




OK

NG

3.INSPECT LOWER TAIL GATE LOCK ASSEMBLY LH
a.

Remove the lower tail gate lock assembly LH (See page Vehicle Exterior>DOOR / HATCH>BACK DOOR>DISASSEMBLY).


b.

Inspect the lower tail gate lock assembly LH (See page Vehicle Exterior>DOOR / HATCH>BACK DOOR>INSPECTION).



OK

4.CHECK HARNESS AND CONNECTOR (LOWER TAIL GATE LOCK ASSEMBLY LH - NO. 2 MAIN BODY ECU AND BODY GROUND)

NG

REPLACE LOWER TAIL GATE LOCK ASSEMBLY LH

4.CHECK HARNESS AND CONNECTOR (LOWER TAIL GATE LOCK ASSEMBLY LH - NO. 2 MAIN BODY ECU AND BODY GROUND)
a.

Disconnect the h5 lower tail gate lock assembly LH connector.


b.

Disconnect the L50 and L51 No. 2 main body ECU connectors.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
h5-1 (HAF) - L51-9 (HAF) Always Below 1 Ω
h5-2 (FUL) - L51-4 (FUL) Always Below 1 Ω
h5-4 (POL) - L50-15 (POL) Always Below 1 Ω
h5-3 (E1) - Body ground Always Below 1 Ω
h5-1 (HAF) - Body ground Always 10 kΩ or higher
h5-2 (FUL) - Body ground Always 10 kΩ or higher
h5-4 (POL) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR