The power back door main switch only turns on while the switch is being pressed, and turns off when the switch is released.
When the power back door main switch is on, a power back door operation request signal is input to the power back door unit assembly (power back door ECU).
Check the Data List for proper functioning of the power back door main switch (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| PBD Main SW | Power back door main switch / ON or OFF | ON: Power back door main switch is not pushed
OFF: Power back door main switch is pushed |
- |
The display is as specified in the normal condition.
OK
NG
Remove the power back door main switch (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR MAIN SWITCH>REMOVAL).
Inspect the power back door main switch (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR MAIN SWITCH>INSPECTION).
OK
NG
Disconnect the E104 power back door main switch connection.
Disconnect the L52 power back door unit assembly (power back door ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E104-9 (MSW) - L52-17 (MSW) | Always | Below 1 Ω |
| E104-6 (MSE) - Body ground | Always | Below 1 Ω |
| E104-9 (MSW) - Body ground | Always | 10 kΩ or higher |
OK
NG