Use the same procedure for the LH and RH sides.
The procedure listed below is for the LH side.
85035
1.INSTALL WASHER NOZZLE SUB-ASSEMBLY (w/ PTC Heater)
Connect the hose.
Attach the 4 claws to install the washer nozzle.
Connect the connector and attach the connector clamp.
85035
2.INSTALL WASHER NOZZLE SUB-ASSEMBLY (w/o PTC Heater)
Attach the 3 clamps to install the washer nozzle.
Connect the hose.
55781E
3.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
53383
4.INSTALL HOOD TO COWL TOP SEAL
53883F
5.INSTALL FRONT FENDER MAIN SEAL LH
53882H
6.INSTALL FRONT FENDER MAIN SEAL RH
53292A
7.INSTALL UPPER RADIATOR SUPPORT SEAL
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
9.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
10.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH