Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55317A
3.REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)
55317A
4.REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)
55607
5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
67913B
6.REMOVE FRONT DOOR SCUFF PLATE RH
73990
7.REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)
55312
8.REMOVE LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)
55476A
9.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55443D
10.REMOVE INSTRUMENT PANEL BOX DOOR KNOB
55433B
11.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
85943
12.REMOVE WINDSHIELD WIPER ECU
Disconnect the 2 connectors.
Remove the bolt and windshield wiper ECU.