Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Front Passenger Side) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255607 KNEE AIRBAG ASSEMBLY(for Front Passenger Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Front Passenger Side)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RHD and LHD.

·

The procedures listed below are the LHD side.



PROCEDURE

Hide 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55402C 4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55607 5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 73990 6.REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

a.

Remove the 4 bolts.

B449545E01
0.427,0.052 1.208,0.323 0.781,0.271 12 false for LHD: 4.021,0.052 4.802,0.323 0.781,0.271 12 false for RHD:


b.

Detach the 4 claws and remove the front passenger side knee airbag.


c.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.