Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE SPIRAL CABLE
Remove the spiral cable (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).
84650
3.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
84140
4.REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
for clamp Type:
| *A | for Clamp Type |
| *B | for Press Fit Type |
Disconnect the connector.
While loosening the band clamp as shown in the illustration, detach the claw to remove the dimmer switch.
for Press Fit Type:
Disconnect the connector.
Pull the headlight dimmer switch toward the seat to detach the 2 claws and remove it.