Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › from 2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255805 HAZARD WARNING SWITCH A

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84330 1.INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/o Audio)

a.

Attach the 2 claws to install the hazard warning switch assembly to the center No. 1 instrument cluster finish panel.


Hide 55412C 2.INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Audio)

Hide 83910 3.INSTALL CLOCK ASSEMBLY (for Radio and Display Type (Hazard Warning Switch))

a.

Install the clock assembly with the 2 screws.


Hide 86120 4.INSTALL RADIO RECEIVER ASSEMBLY (for Radio and Display Type)

Hide 86110B 5.INSTALL MULTI-DISPLAY ASSEMBLY (w/ Navigation System (Hazard Warning Switch))

a.

Connect each connector.


b.
E338536

Insert the multi-display assembly and attach the 8 claws on its backside.

NOTICE:

When inserting the multi-display assembly, do not press the knobs on it.



c.

Install the 2 bolts and 2 screws.

Torque:
for Bolt : 8.5 N*m (87 kgf*cm, 75 in.*lbf)


Hide 55680A 6.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55670 7.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55510F 8.INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).