Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR WINDOW FRAME MOULDING › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255843 FRONT DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR WINDOW FRAME MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.



Standard Heating Temperature:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body and window frame moulding excessively.


PROCEDURE

Hide 75756C 1.INSTALL FRONT DOOR REAR WINDOW FRAME MOULDING LH

a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove the double-sided tape from the vehicle body surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new window frame moulding.

i.

Using a heat light, heat a new window frame moulding and the vehicle body surface.


ii.

Remove the peeling paper from the face of the window frame moulding.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



iii.
B182608E07
1.25,1.042 1.573,1.042 false 0.427,0.979 1.281,1.573 0.854,0.594 10 false Double-sided Tape

Attach the clip and double-sided tape to install the window frame moulding.

HINT:

Press the window frame moulding firmly to install it.




Hide 75720 2.INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH

Hide 68151E 3.INSTALL FRONT DOOR GLASS RUN LH

Hide 68102 4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 68172A 5.INSTALL FRONT INNER DOOR GLASS WEATHERSTRIP LH

Hide 67832 6.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 87940 7.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 67602 8.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74646 9.INSTALL DOOR ASSIST GRIP COVER LH

Hide 74240A 10.INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

Hide 69278B 11.INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

Hide 67492A 12.INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).