Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR WINDOW FRAME MOULDING › from 2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255843 FRONT DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR WINDOW FRAME MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When removing window frame moulding, heat the vehicle body and window frame moulding using a heat light.



Standard Heating Temperature:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body and window frame moulding excessively.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67492A 3.REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

Hide 69278B 4.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

Hide 74240A 5.REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

Hide 74646 6.REMOVE DOOR ASSIST GRIP COVER LH

Hide 67602 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 87940 8.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 67832 9.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 68172A 10.REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH

Hide 68102 11.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 68151E 12.REMOVE FRONT DOOR GLASS RUN LH

Hide 75720 13.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

Hide 75756C 14.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH

B182608E06
1.385,0.365 0.76,0.719 0.76,0.719 0.76,0.833 false 1.781,1.167 2.208,1.281 2.208,1.281 2.208,1.438 false 1.802,1.427 3,1.75 1.198,0.323 10 false Double-sided Tape 0.365,0.833 1.385,1.104 1.021,0.271 10 false Protective Tape

a.

Put protective tape around the window frame moulding.


b.

Detach the clip and remove the double-sided tape to remove the window frame moulding.