Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Rear Door) › from 2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255852 BLACK OUT TAPE(for Rear Door) A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE(for Rear Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When removing the No. 2 black out tape LH, No. 6 black out tape LH, upper inner black out tape LH, rear inner black out tape LH, and rear door front window frame moulding LH, heat the vehicle body, No. 2 black out tape LH, No. 6 black out tape LH, upper inner black out tape LH, rear inner black out tape LH, and rear door front window frame moulding LH using a heat light.



Standard Heating Temperature:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
No. 2 Black Out Tape LH 20 to 30°C (68 to 86°F)
No. 6 Black Out Tape LH 20 to 30°C (68 to 86°F)
Upper Inner Black Out Tape LH 20 to 30°C (68 to 86°F)
Rear Inner Black Out Tape LH 20 to 30°C (68 to 86°F)
Rear Door Front Window Frame Moulding LH 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body, No. 2 black out tape LH, No. 6 black out tape LH, upper inner black out tape LH, rear inner black out tape LH, and rear door front window frame moulding LH excessively.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 69278C 3.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

Hide 74272A 4.REMOVE REAR DOOR UPPER ARMREST BASE PANEL LH

Hide 74611C 5.REMOVE ASSIST GRIP COVER LH

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68174C 7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67842E 8.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 68152C 9.REMOVE REAR DOOR GLASS RUN LH

Hide 67408F 10.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

Hide 68124C 11.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 68104 12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 75740 13.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

Hide 75762A 14.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING LH

Hide 67674A 15.REMOVE REAR DOOR FRAME GARNISH LH

Hide 67676C 16.REMOVE REAR DOOR NO. 2 FRAME GARNISH LH

Hide 68640A 17.REMOVE REAR DOOR CHECK ASSEMBLY LH

Hide 67872 18.REMOVE REAR DOOR WEATHERSTRIP LH

a.
B433690

w/o Spot Cover:

i.

Detach the 4 clips, and remove the upper part of the rear door weatherstrip LH so that the black out tape can be removed.



b.

w/ Spot Cover:

i.

Remove the rear door weatherstrip LH (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>DISASSEMBLY).



Hide 75924C 19.REMOVE NO. 2 BLACK OUT TAPE LH

B182616

a.

Pull back an edge of the No. 2 black out tape LH and pull it parallel to the vehicle body to remove it.


Hide 75936A 20.REMOVE NO. 6 BLACK OUT TAPE LH

B182620

a.

Pull back an edge of the No. 6 black out tape LH and pull it parallel to the vehicle body to remove it.


Hide 75938 21.REMOVE UPPER INNER BLACK OUT TAPE LH

B182622

a.

Pull back an edge of the upper inner black out tape LH and pull it parallel to the vehicle body to remove it.


Hide 75954A 22.REMOVE REAR INNER BLACK OUT TAPE LH

B182618

a.

Pull back an edge of the rear inner black out tape LH and pull it parallel to the vehicle body to remove it.