Home › Vehicle Exterior › WINCH › REMOTE CONTROL SWITCH › from 2015.08
RM2660E _59 Vehicle Exterior _052858 WINCH _0255864 REMOTE CONTROL SWITCH G

WINCH  REMOTE CONTROL SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 52049 1.REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY

a.
B425631E03
2.854,1.729 2.51,1.729 false 2.906,1.677 3.167,1.917 0.26,0.24 10 true *a

Put protective tape around the front bumper winch cover sub-assembly.

Text in Illustration
*a Protective Tape


b.

Using moulding remover A, detach the 2 claws.


c.
B425632

Detach the 2 guides and remove the front bumper winch cover sub-assembly as shown in the illustration.


Hide 38640 2.INSPECT REMOTE CONTROL SWITCH ASSEMBLY

a.
B425636

Connect the remote control switch connector.


b.
B167941

Turn the ignition switch on (IG) and check that the power indicator light illuminates.


c.

Press the remote control switch, and check that the winch operates.

NOTICE:

Be careful not to tighten or strain the winch wire.



d.

Turn the ignition switch off.


Hide 52119A 3.REMOVE FRONT BUMPER COVER

Hide 4.INSPECT OVERHEAT TEMPERATURE INDICATOR

a.
B180478

Remove the 4 screws and cover.


b.
B180479

Disconnect the motor relay connector.


c.
B425633

Remove the 2 nuts.


d.

Pull the bumper side winch control wire out of the bumper.


e.

Connect the bumper side winch control wire connector to the vehicle side winch control wire connector.


f.

Connect the bumper side winch control wire connector to the winch control switch connector.


g.
B167943

Turn the ignition switch on (IG) and check that the overheat temperature indicator light illuminates and the buzzer sounds.


h.

Turn the ignition switch off.


i.

Disconnect the bumper side winch control wire connector from the winch control switch connector.


j.

Disconnect the bumper side winch control wire connector from the vehicle side winch control wire connector.


k.

Pass the bumper side winch control wire through the bumper.


l.

Install the 2 nuts.


m.

Connect the motor relay connector.


n.

Install the cover with the 4 screws.


Hide 52049 6.INSTALL FRONT BUMPER WINCH COVER SUB-ASSEMBLY

a.

Attach the 2 guides to install the front bumper winch cover sub-assembly.


b.

Attach the 2 claws.