Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255517 PARKING ASSIST MONITOR SYSTEM Y

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the parking assist monitor system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.

HINT:

The parking assist monitor display may be temporarily distorted due to radio waves around the vehicle.

Problem Symptom Cause
Both of the following conditions are met:
·

The problem symptom indicates a parking assist monitor display malfunction and the problem symptom cannot be reproduced.

·

DTC C1622 is output as "Hist" only.*


The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.

*: DTCs output as "Hist" will not be output again after DTCs are cleared.




Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

4.CHECK VEHICLE TYPE
4.CHECK VEHICLE TYPE
a.

Check the vehicle type.


Result:
Result Proceed to
w/o Navigation System A
w/ Navigation System B



A

5.CHECK AUDIO AND VISUAL SYSTEM (w/ Multi-display)

B

12.CHECK NAVIGATION SYSTEM
5.CHECK AUDIO AND VISUAL SYSTEM (w/ Multi-display)

Result:
Result Proceed to
Audio and visual system (w/ Multi-display) is normal A
Audio and visual system (w/ Multi-display) is abnormal B



A

B

6.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
6.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output (for LHD) B
CAN communication system DTCs are output (for RHD) C



A

7.CHECK DTC

B

C

7.CHECK DTC
a.

Check for DTCs and make a note of any codes that are output.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR



c.

Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.


Result:
Result Proceed to
No DTCs are output A
DTCs are output B



A

8.PROBLEM SYMPTOMS TABLE

B

8.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

9.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

9.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

10.ADJUST, REPAIR OR REPLACE
10.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

11.CONFIRMATION TEST
11.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END

12.CHECK NAVIGATION SYSTEM

Result:
Result Proceed to
Navigation system is normal A
Navigation system is abnormal B



A

B

6.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*