The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
+*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the DTC Check / Clear.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Check Mode Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Road Test.
| Result | Proceed to |
|---|---|
| Symptom does not occur | A |
| Symptom occurs | B |
A
B
Refer to the Electronic Circuit Inspection Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the DTC Check / Clear.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to the Park/Neutral Position Switch.
Refer to the Shift Lever Assembly (Click here Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER(w/ Entry and Start System)>ON-VEHICLE INSPECTION w/ Entry and Start System,Click here Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER(w/o Entry and Start System)>ON-VEHICLE INSPECTION w/o Entry and Start System ).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Mechanical System Tests.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Hydraulic Test.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Manual Shifting Test.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Problem Symptoms Table.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Problem Symptoms Table.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the Diagnostic Trouble Code Chart.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT