Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) › 2015.08–2017.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255573 ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System) Y

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use this procedure to troubleshoot the engine immobiliser system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
HINT:
·

In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points for problem analysis:

What Vehicle model, system name
When Date, time, occurrence frequency
Where Whether the problem occurs at a specific location.
Under what conditions? Whether the doors were locked or unlocked, whether the engine switch was on, whether the engine was running.
How did it happen? Problem symptoms



Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

HINT:

A simple method to determine whether the battery is discharged is to operate the horn.



Result:
Proceed to
NEXT



NEXT

4.TURN ENGINE SWITCH ON (IG)
4.TURN ENGINE SWITCH ON (IG)
NOTICE:

When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.


Result:
Proceed to
NEXT



NEXT

5.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
5.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Using the GTS, check for CAN communication system DTCs.


Result:
Result Proceed to
CAN DTCs are not output A
CAN DTCs are output (for LHD with Central Gateway ECU) B
CAN DTCs are output (for RHD with Central Gateway ECU) C
CAN DTCs are output (for LHD without Central Gateway ECU) D
CAN DTCs are output (for RHD without Central Gateway ECU) E




A

6.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

B

C

D

E

6.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
a.

Using the GTS, check for LIN communication system DTCs.

Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR

Result:
Result Proceed to
LIN DTCs are not output A
LIN DTCs are output B




A

7.CHECK FOR DTC*

B

7.CHECK FOR DTC*

b.

Based on the DTCs output above, proceed to each diagnostic procedure.

Result:
Result Proceed to
DTCs are not output A
Engine DTCs are output (for 3UR-FE) B
Engine DTCs are output (for 1UR-FE) C
Engine DTCs are output (for 1GR-FE) D
Engine DTCs are output (for 1VD-FTV (w/ DPF)) E
Engine DTCs are output (for 1VD-FTV (w/o DPF)) F
Steering lock system DTCs are output G
Engine immobiliser system DTCs are output H




A

8.PROBLEM SYMPTOMS TABLE

B

C

D

E

F

G

H

8.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B




A

9.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

10.REPAIR OR REPLACE
HINT:

If the certification ECU (smart key ECU assembly), ID code box (immobiliser code ECU), steering lock ECU (steering lock actuator assembly), main body ECU (multiplex network body ECU), ECM, or electrical key transmitter sub-assembly are replaced, refer to Service Bulletin.


Result:
Proceed to
NEXT



NEXT

11.CHECK FOR DTC*
11.CHECK FOR DTC*

b.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)>DTC CHECK / CLEAR

HINT:

Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.


Result:
Result Proceed to
DTCs are not output A
Engine immobiliser system DTCs are output B




A

END

B