Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER(for Double Swing Out Type)
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255855 REAR BUMPER(for Double Swing Out Type) A

EXTERIOR PANELS / TRIM  REAR BUMPER(for Double Swing Out Type)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 58724B 1.INSTALL NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

a.

Install the No. 2 luggage compartment side cover protector with 2 new grommets.


b.

Install the 2 screws.


Hide 58723B 2.INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

HINT:

Use the same procedure described for the No. 2 luggage compartment side cover protector.


Hide 57616B 3.INSTALL REAR BUMPER ARM BRACKET LH

a.

Install the rear bumper arm bracket with the 2 bolts and nut.


b.

Attach the clamp.


Hide 57615C 4.INSTALL REAR BUMPER ARM BRACKET

HINT:

Use the same procedure for both rear bumper arm brackets.


a.

Install the rear bumper arm bracket with the bolt.


Hide 52172B 5.INSTALL REAR BUMPER NO. 2 REINFORCEMENT

a.

Install the rear bumper No. 2 reinforcement with the 2 bolts.


Hide 52156A 6.INSTALL REAR BUMPER SIDE SUPPORT LH

a.

Attach the 6 claws to install the rear bumper side support.


b.

Install the 3 screws.


Hide 52155A 7.INSTALL REAR BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure described for the LH side.


Hide 52563D 8.INSTALL REAR BUMPER UPPER RETAINER LH

a.

Attach the 2 clips to install the rear bumper upper retainer.


Hide 52562E 9.INSTALL REAR BUMPER UPPER RETAINER RH

HINT:

Use the same procedure described for the LH side.


Hide 11.INSTALL REAR COMBINATION LIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52159 12.INSTALL REAR BUMPER COVER

a.

Open the back doors one notch.


b.

Attach the 14 claws to install the rear bumper cover.


c.

Connect the No. 2 frame wire connector.


d.

Install the 5 bolts and 2 clips.


e.

Install the 2 bolts, 2 clips and 6 screws.


Hide 52162B 13.INSTALL REAR BUMPER NO. 1 PLATE

a.

Attach the 20 claws to install the rear bumper No. 1 plate.


Hide 76626E 14.INSTALL REAR QUARTER PANEL MUDGUARD LH

Hide 76625G 15.INSTALL REAR QUARTER PANEL MUDGUARD RH

Hide 51980A 16.INSTALL PINTLE HOOK ASSEMBLY (w/ Pintle Hook)

Hide 51903B 17.INSTALL SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)

Hide 51902A 18.INSTALL SPARE WHEEL COVER SUB-ASSEMBLY (w/ Tire Carrier)

Hide 51937C 19.INSTALL SPARE WHEEL CARRIER HINGE BRACKET (w/ Tire Carrier)