If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
76626E
1.REMOVE REAR QUARTER PANEL MUDGUARD LH
76625G
2.REMOVE REAR QUARTER PANEL MUDGUARD RH
52162B
3.REMOVE REAR BUMPER NO. 1 PLATE
Put protective tape around the rear bumper No. 1 plate.
Detach the 20 claws and remove the rear bumper No. 1 plate.
| *a | Protective Tape | - | - |
52159
4.REMOVE REAR BUMPER COVER
Put protective tape around the bumper cover.
Use the same procedure for the other side.
| *a | Protective Tape |
Open the tail gate and remove the 4 clips.
Close the tail gate.
Remove the 2 bolts, 6 screws and 2 clips.
| *a | Bolt |
Remove the 5 bolts.
Detach the 7 claws.
Use the same procedure for the other side.
Remove the rear bumper cover.
w/ TOYOTA Parking Assist-sensor System:
Disconnect the No. 2 frame wire connector.
58724B
5.REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Remove the 2 screws, 2 grommets and No. 2 luggage compartment side cover protector.
58723B
6.REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Use the same procedure described for the LH side.
81560
7.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
81550
8.REMOVE REAR COMBINATION LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52563D
9.REMOVE REAR BUMPER UPPER RETAINER LH
Detach the 2 clips and remove the rear bumper upper retainer LH.
52562E
10.REMOVE REAR BUMPER UPPER RETAINER RH
Use the same procedure described for the LH side.
52156A
11.REMOVE REAR BUMPER SIDE SUPPORT LH
Remove the 3 screws.
Detach the 6 claws and remove the rear bumper side support LH.
52155A
12.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52172B
13.REMOVE REAR BUMPER NO. 2 REINFORCEMENT
Remove the 2 bolts and rear bumper No. 2 reinforcement.
57615C
14.REMOVE REAR BUMPER ARM BRACKET
Remove the bolt and rear bumper arm bracket.
Use the same procedure for both bumper arm brackets.
57616B
15.REMOVE REAR BUMPER ARM BRACKET LH
Detach the clamp.
Remove the 2 bolts and rear bumper arm bracket LH.