1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
53805
3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
53875A
4.REMOVE FRONT FENDER LINER RH
Remove the screw, and disconnect the front fender liner RH from the front bumper cover.
Using a T30 "TORX" socket, remove the 3 screws.
Remove the 5 clips.
Partially remove the front fender liner RH.
It is not necessary to fully remove the front fender liner RH. Partially remove it so that the air pump assembly can be removed.
53736G
5.REMOVE FRONT FENDER APRON SEAL FRONT RH
11209
6.REMOVE V-BANK COVER SUB-ASSEMBLY
17880
7.REMOVE AIR CLEANER HOSE ASSEMBLY
17700
8.REMOVE AIR CLEANER ASSEMBLY
17342
9.REMOVE NO. 2 AIR INJECTION SYSTEM HOSE
Engine Room Side:
| *a | Engine Room Side |
| *b | Front Fender RH Inside |
Detach the 2 clamps.
Slide the clamp indicated by the arrow in the illustration and disconnect the No. 2 air injection system hose from the air tube sub-assembly.
Front Fender RH Inside:
Slide the clamp and disconnect the No. 2 air injection system hose from the air pump assembly.
17343
10.REMOVE NO. 3 AIR INJECTION SYSTEM HOSE
Engine Room Side:
| *a | Engine Room Side |
| *b | Front Fender RH Inside |
Detach the clamp.
Slide the clamp indicated by the arrow in the illustration and disconnect the No. 3 air injection system hose from the air tube sub-assembly.
Front Fender RH Inside:
Detach the clamp.
Slide the clamp indicated by the arrow in the illustration and disconnect the No. 3 air injection system hose from the air pump assembly.
11.REMOVE AIR PUMP ASSEMBLY WITH BRACKET
Disconnect the 2 air pump assembly connectors to detach the 3 wire harness clamps.
Remove the 2 bolts, 2 nuts and air pump assembly with bracket.
17621A
12.REMOVE AIR PUMP INLET
Remove the 2 bolts.
| *1 | No. 1 Air Injection System Hose |
| *2 | Air Pump Inlet |
Disconnect the air pump inlet from the 2 No. 1 air injection system hoses to remove it.
17341
13.REMOVE NO. 1 AIR INJECTION SYSTEM HOSE
Remove the 2 No. 1 air injection system hoses.
17610C
14.REMOVE AIR PUMP ASSEMBLY
Using a clip remover, detach the 2 wire harness clamps and remove the 2 air pump assemblies from the air pump bracket.
Disconnect the 6 air pump insulators.