| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil cooler assembly removal/installation are shown below.
51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
2.DRAIN AUTOMATIC TRANSMISSION FLUID
3.DRAIN ENGINE COOLANT
16281N 4.DISCONNECT NO. 4 WATER BY-PASS HOSE
16267C 5.DISCONNECT NO. 3 WATER BY-PASS HOSE
32943C 6.DISCONNECT NO. 3 TRANSMISSION OIL COOLER HOSE
32943 7.DISCONNECT NO. 1 TRANSMISSION OIL COOLER HOSE
32910 8.REMOVE OIL COOLER ASSEMBLY